Can I do midi in and out? Does the Daughterboard support stereo & dig audio in?

You are here:
Estimated reading time: 2 min

The Replay1

The 68060 Daughterboard also has a stereo 3.5 mm audio input jack for recording and sampling. Stereo output is via the Replay Baseboard via the 3.5mm stereo jack.
Note: Recording and Sampling will be Core Specific and dependent on drivers and software applications etc.

The Replay1 MIDI Interface is connected via 4 pin headers at the front of the Daughterboard. The MIDI Breakout Board gives you access to the MIDI communication protocol, so you can control synthesizers, sequencers, and other musical devices. The MIDI Breakout Board provides an opto-isolated MIDI-IN port as well as a MIDI-OUT port, and works at both 5V and 3.3V logic levels for easy communication with virtually all micro controller boards. The board can be purchased from hobbytronics.

Features…MIDI-OUT and MIDI-IN ports. 4x3mm Mounting holes. Board Size 33mm x 54mm. Fully tested and assembled.

Note Daughterboard MIDI connections:
At this time, only the P2 Comms1 port is working, further work is required for P3 Comms2.

Comms1 (P2)
5V -> Pin 1 (marked with an arrow/triangle)
0V -> Pin 2
MIDI IN -> Pin 3
MIDI OUT -> Pin 4

Comms2 (P3)
5V -> Pin 1 (marked with an arrow/triangle)
0V -> Pin 2
MIDI IN -> Pin 3
MIDI OUT -> Pin 4

 

Was this article helpful?
Dislike 0
Views: 200